stradela 1, Sihastrului 19 or. Codru, mun. Chişinău

Tel.: +373 69 13 73 60; Fax: +373 22 28 26 42; Email: convendalux@mail.ru

stradela 1, Sihastrului 19 or. Codru, mun. Chişinău

Tel.: +373 69 13 73 60; Fax: +373 22 28 26 42; Email: convendalux@mail.ru

Security seal Sprut-2

Sprut 2 - is a universal device for sealing the control and measurement instrumentation, electrical cabinets, mail, cargo, freight transportation, as well as container, doors, windows and any other objects. In contrast to other similar devices in the series "Sprut", this model has a reliable locking ring capable of protecting the seal from the access to the core. At the end of the final assembly, housing and seal protector ring are welded into a single unit. The welding process is performed by means of special equipment.

Characteristics of devices:

- High level of resistance temperature highs and lows (from -50 "C to +90" C).
- Harmlessness of the materials from which made housing and other details seals (PET, thermoplastic).
- Strong and seized a core of polystyrene.
- Different colored fillings (7 colors).
- The possibility of applying the code of 7 digits on the seal cover (stamping and laser marking).
- The availability of the application of emblems or logos on the body of the seal.
- The seals can be assembled without special pliers.
- A thin and high-strength galvanized steel cable (diameter less than 1mm), which does not break due to accidental physical contact during transport.

Attention! The core of the seal is able to rotate in one direction only, which guarantees absolutely unacceptable that the device is removed and then used again. This Octopus TAL guarantees one hundred percent control of sealed objects.

The installation method seals?

1) First, select the correct length of wire, with the expectation that in the assembled state of the seal, the cable ends should protrude approximately 10 mm from the device holes.
2) To thread the cable, you must turn the heart of the seal is the core and shell seals the holes are not aligned. Then, after threading wire through the holes, the core of the seal must be at 1.5 turns.
3) The second end of the wire must be inserted into the other hole based on that the length of both sides of the wire was the same. After that, the wire must be tightly roll up around the device.

Attention! To lock the seal must be turned 4 times the core of the seal!